The device works with 98/88/A8/A9/39/AA

Supported vehicles:

Toyota:  Camry 2012-2020; Land Cruiser 200 2015-2020; Land Cruiser Prado 2015-2020; Rav 4 2016-2020; Corolla 2015-2020; CHR 2016-2019

Lexus: NX;RX 2016+; GX 2015+; IS 2015+;GS 2015+; ES 2015-2020; LX 2015-2020; LS 2015-2020.

The device allows you to start the engine within 10 seconds on new models of Toyota / Lexus with a new smart key system (05/2017 +), on which there is no possibility to write keys through the OBD2 connector, as well as on earlier models. The device allows you to start the engine even when the start/stop button is faulty or switch off and if there are additional locks or breaks of Can bus or Lin bus. The device can be connected either to the connector of the steering lock and to OBD2 or only to the connector of the car certification unit. The device works automatically after such connection so to start the engine it is enough to open-close the driver’s door!

Also, using AST PRO, one can reset the ID Immo unit by installing a new smart key certification unit and easy to program a new set of keys.

Device for the emergency shutdown of the factory security system Toyota / Lexus (2017+).

Outside the car, the device is connected to the headlight connector, and inside the car - to the BCM module.

List of covered models Toyota/Lexus:

Toyota:  Land Cruiser Prado 150(2018+), Land Cruiser 200(2017+), Alphard(2017+), Camry(2018+), RAV4(2019+), Corolla(2019+)

Lexus: LX 570/450D(2017+), RX(2016+), NX(2016+), ES(2018+)

The device works with 98/A8/A9/AA smart-keys.
Supported vehicles:
Toyota: Camry 2018+; Land Cruiser 200 2015-2020;Land Cruiser Prado 2015-2020;Rav 4 2018+;CHR 2017+
Lexus: NX;RX 2016+; GX 2015+; IS 2015+;GS 2015+; ES 2018+; LX 2015-2018+; LS 2015-2018+.

The device is designed specifically for emergency unlocking of the steering wheel of Toyota / Lexus cars (2008-2020). It is enough to connect the device to the steering wheel lock and after a few seconds, the steering wheel will be unlocked.

• It covers almost all models of Toyota/Lexus (2008 -2017)  with KEYLESS-GO system
• This device unlocks the smart modules and programs the smart keys with the following type of chips: D4/94/98/88/A8/A9
• For unlocking and programming you need only plug the device into the car’s OBD 2 connector
• The smart key Programming takes up to 5 minutes

Toyota /Lexus models: ALMOST ALL MODELS WITH KEYLESS-GO SYSTEM (2008+).

The device programs smart-keys with D4/94/98/88/A8/A9 passwords.

Covered Toyota /Lexus models: ALMOST ALL MODELS WITH KEYLESS-GO SYSTEM (2008+).

The device unlocks of smart-module and programs smart-keys with D4/94/98/88/A8/A9 passwords.

ProSmart v3.1 is special OBD adapter with the needle-probe for connection via LIN bus of the vehicle.

The device ProSmart v3.1 is designed for emergency start of the car and programming the keys in case of their loss.

ProSmart 3.1 works with SmartKey system that uses new generation SmartEcu

(* See SKU numbers of Smart ECU units). Access to the contents of SmartEcu memory in such systems is impossible. These systems are used in cars 2015-2020.

• Lexus: GX, LS, LX, NX, RX
• Toyota: Camry, CHR, Highlander, Land Cruiser, Land Cruiser Prado, RAV4

Smart keys with ID 88, A8, A9, AA are used in systems with SmartECU of the new generation.

Attention ! ProSmart v3.1 performs emergency start car and key programming using another SmartECU (new or used ECU with a key binded to this unit ).